crypto ipsec policy
Create a crypto policy used by ipsec.
Syntax
crypto ipsec policy
name seq-num
ipsec-manual
To delete a crypto policy entry, use the
no crypto ipsec policy
name seq-
num
ipsec-manual
command.
Parameters
name
Enter the name for the crypto policy set.
seq-num
Enter the sequence number assigned to the crypto policy
entry.
Defaults
none
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
This command creates a crypto policy entry and enters the crypto policy
configuration mode for configuring the flow parameters.
Example
Dell(conf)#crypto ipsec policy West 10 ipsec-manual
Dell(conf-crypto-policy)#
management crypto-policy
Apply the crypto policy to management traffic.
Syntax
management crypto-policy
name
To remove the management traffic crypto policy, use the
no management
crypto-policy
name
command.
Parameters
name
Enter the name for the crypto policy.
Defaults
none
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0)
Introduced on the M I/O Aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
658
Internet Protocol Security (IPSec)