show interfaces configured
— displays any interface with a non-default
configuration.
show interfaces description
Display the descriptions configured on the interface.
Syntax
show interfaces [
interface
] description
Parameters
interface
(Optional) Enter one of the following keywords and slot/port
or number information:
• For Loopback interfaces, enter the keyword
loopback
then a number from 0 to 16383.
• For the management interface on the RPM, enter the
keyword
ManagementEthernet
then the slot/port
information. The slot range is 0-0 and the port range is 0.
• For the Null interface, enter the keywords
null 0
.
• For a Port Channel interface, enter the keywords
port-
channel
then a number. The range is 1 to 128.
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet
then the slot/port information.
• For a 40-Gigabit Ethernet interface, enter the keyword
fortyGigE
then the slot/port information.
• For VLAN interfaces, enter the keyword
vlan
then a
number from 1 to 4094.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 8.3.16.1
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
The following describes the
show interfaces description
command shown
in the Example below.
Field
Description
Interface
Displays the type of interface and associated slot and port
number.
OK?
Indicates if the hardware is functioning properly.
Status
States whether the interface is enabled (up) or disabled
(administratively down).
Protocol
States whether IP is enabled (up) or disabled (down) on the
interface.
586
Interfaces