Defaults
none
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Usage
Information
Do not enter this command before creating the access-list.
ipv6 pim register-filter
Configure the source DR so that it does not send register packets to the RP for the specified sources and
groups.
Syntax
ipv6 pim register-filter
access-list
Parameters
access-list
Enter the name of the extended ACL that contains the
sources and groups to filter.
Defaults
none
Command
Modes
CONFIGURATION
Command
History
Version 9.2(0.0)
Introduced on the MXL 10/40GbE Switch IO Module.
Example
Dell(conf)#ipv6 pim register-filter REG-FIL_ACL
Dell(conf)#ipv6 access-list REG-FIL_ACL
Dell(conf-ipv6-acl)#deny ipv6 165:87:34::10/128 ff0e::
225:1:2:0/112
Dell(conf-ipv6-acl)#permit ipv6 any any
Dell(conf-ipv6-acl)#exit
ipv6 pim rp-address
Configure a static PIM rendezvous point (RP) address for a group. First-hop routers use this address to
send register packets on behalf of the source multicast host.
Syntax
ipv6 pim rp-address
address
group-address
group-address mask
override
To remove an RP address, use the
no ipv6 pim re-address
address
group-
address
mask
override
command.
PIM-Sparse Mode (PIM-SM)
1037