6-156
Cisco Broadband Cable Command Reference Guide
OL-1581-07
Chapter 6 Cable CPE Commands
show crypto engine connections
The following example shows typical output from the
show crypto engine connections dh
command:
Router#
show crypto engine connections dh
Conn ID Status
0 0 1
0 14 1
0 0 1
0 0 1
0 18 1
Router#
Table 6-24
describes the fields shown in the display.
The following example shows typical output from the
show crypto engine connections
dropped-packet
command:
Router#
show crypto engine connections dropped-packet
Table 6-23 show crypto engine connections active Field Description
Field
Description
ID
Identifies the connection by its number. Each active encrypted
session connection is identified by a positive number from 1 to
299. These connection numbers correspond to the table entry
numbers.
Interface
Interface involved in the encrypted session connection.
IP-Address
IP address of the interface.
State
Current state of the connection:
•
alloc—the connection is requesting resources.
•
set—an active connection (normal state).
Algorithm
The encryption algorithms used for this connection. If this field
reads “NONE,” this connection is still being allocated and has
not yet requested an algorithm.
Encrypt
Total number of encrypted outbound IP packets.
Decrypt
Total number of encrypted outbound IP packets.
Table 6-24 show crypto engine connections dh Field Description
Field
Description
Conn
Identifies the connection by its number. Each active encrypted
session connection is identified by a positive number from 1 to
299. These connection numbers correspond to the table entry
numbers.
ID
Identifies the Diffie-Hellman group.
Status
Identifies the Diffie-Hellman status:
1—768-bit Diffie-Hellman prime modulus group.
2—1024-bit Diffie-Hellman prime modulus group.
