4-75
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 4 Commands for the Cisco uBR10012 Router
show pxf cpu
Note
The
noroute
counter increases whenever the router drops a packet because its destination IP address is
0.0.0.0. This counter also increases whenever the Cisco Express Forwarding (CEF) adjacency tables
drop a packet because it has a null, discard, or drop adjacency.
Subblocks
The following example shows a typical display for the
subblocks
option for all interfaces:
Router#
show pxf cpu subblocks
Interface Status ICB WQB_ID Fwding Encap VCCI map VCCI
POS1/0/0 initiali 6000 6146 disable 5 81800000 E
GigabitEthernet3/0/0 reset E000 6148 disable 1 81800004 1
GigabitEthernet4/0/0 up 12000 6150 PXF 1 81800008 2
Cable5/0/0 down 14000 4096 disable 59 81805400 3
Cable5/0/1 down 14100 4097 disable 59 81805C00 4
Cable5/1/0 up 16000 4098 PXF 59 81806400 5
Cable6/0/0 up 18000 4099 PXF 59 81806C00 6
Cable6/0/1 up 18100 4100 PXF 59 81807400 7
Cable6/1/0 up 1A000 4101 PXF 59 81807C00 8
Cable6/1/1 up 1A100 4102 PXF 59 81808400 9
Cable7/0/0 up 1C000 4103 PXF 59 81808C00 A
Cable7/1/0 up 1E000 4104 PXF 59 81809400 B
Cable7/1/1 up 1E100 4105 PXF 59 81809C00 C
Cable7/1/1.1 up 1E100 4105 PXF 59 8180A400 D
Router#
The following example shows a typical display for the
subblocks
option for a particular cable interface:
Router#
show pxf cpu subblocks c7/1/1
Cable7/1/1 is up
ICB = 1E100, WQB_ID = 4105, interface PXF, enabled
MAC Domain = 2
IOS encapsulation type 59 MCNS
Min mtu: 18 Max mtu: 1538
VCCI maptable location = 81809C00
VCCI C
icmp ipaddress 0.0.0.0 timestamp 0
Router#
Table 4-11
describes the fields shown in the display for the
show pxf cpu subblocks
command.