3-105
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 3 Cisco CMTS Show Commands
show cable modem qos
show cable modem qos
To display quality of service (QoS) and service flow information for a particular CM, use the
show cable
modem qos
command in privileged EXEC mode.
show cable modem
{
ip-address
|
mac-address
}
qos
[
verbose
]
Syntax Description
Command Modes
Privileged EXEC
Command History
Usage Guidelines
This command displays the service flows currently in use by a CM. The default form of the display
shows one service flow per line, while the
verbose
form displays complete information for each flow.
Note
Also see the information about this command’s behavior in a Hot Standby Connection-to-Connection
Protocol (HCCP) configuration, see the
“Operation with Hot Standby Connection-to-Connection
Protocol (HCCP) Configuration” section on page 3-54
.
Examples
The following example shows sample output for the
show cable modem qos
command for a particular
CM, as identified by its MAC address:
Router#
show cable modem 0010.7bb3.fcd1 qos
Sfid Dir Curr Sid Sched Prio MaxSusRate MaxBrst MinRsvRate Throughput
State Type
3 US act 1 BE 7 2000000 1522 100000 0
4 DS act N/A BE 0 4000000 1522 0 0
Router#
The following example shows sample output for the
show cable modem qos
command for a particular
CM, as identified by its IP address:
Router#
show cable modem 22.1.1.10 qos
Sfid Dir Curr Sid Sched Prio MaxSusRate MaxBrst MinRsvRate Throughput
State Type
7 US act 3 BE 0 0 3044 0 0
ip-address
Displays the QoS information for the specific CM, as identified by its IP
address.
mac-address
Displays the QoS information for the specific CM, as identified by its MAC
address.
verbose
(Optional) Displays detailed information for each service flow ID (SFID)
for the CM.
Release
Modification
11.3XA
This command was introduced.