3-228
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 3 Cisco CMTS Show Commands
show interface cable service-flow
show interface cable service-flow
To display the attributes of DOCSIS service flows on a given cable interface, use the
show interface
cable service-flow
command in privileged EXEC mode.
show interface cable
{
slot/port
|
slot
/
subslot
/
port
}
service-flow
show interface cable
{
slot/port
|
slot
/
subslot
/
port
}
service-flow
sfid
[
classifiers
|
counters
|
phs
|
qos
] [
verbose
]
Syntax Description
Command Modes
Privileged EXEC
Command History
slot/port
Identifies the cable interface and downstream port on the Cisco uBR7100
series and Cisco uBR7200 series routers.
On the Cisco uBR7100 series router, the only valid value is
1/0
. On the
Cisco uBR7200 series router,
slot
can range from 3 to 6, and
port
can be 0
or 1, depending on the cable interface.
slot/subslot/port
Identifies the cable interface on the Cisco uBR10012 router. The following
are the valid values:
•
slot
= 5 to 8
•
subslot
= 0 or 1
•
port
= 0 to 4 (depending on the cable interface)
sfid
(Optional) Identifies the service flow index (1 to 65535).
classifiers
[
clid
]
(Optional) Displays all classifiers associated with this service flow or
optionally display information only for the specified classifier ID (
clid
,
1 to 65535).
counters
(Optional) Displays the real-time counters for the service flow for a specific
SFID.
phs
(Optional) Displays packet header suppression rules and packet counters for
the service flow for a specific SFID.
Note
The PHS packet counters are not supported on the Cisco uBR-
MC5X20 card and always shows 0 or N/A, depending on the
software release.
qos
(Optional) Displays QoS information for the service flow for a specific
SFID.
verbose
(Optional) Displays detailed information on the service flow for a specific
SFID.
Release
Modification
12.1(4)CX
This command was introduced.
