3-24
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 3 Cisco CMTS Show Commands
show cable filter
show cable filter
To display the DOCSIS 1.1 filter groups that are currently defined, use the
show cable filter
command
in user EXEC or privileged EXEC mode.
show cable filter
[
group
group-index
[
index
index-num
]] [
verbose
]
Syntax Description
Command Modes
User EXEC, Privileged EXEC
Command History
Examples
The following example shows a typical display of the
show cable filter
command:
Router#
show cable filter
Filter SrcAddr/Mask DestAddr/Mask Prot ToS SPort DPort TCP Action Status
Grp Id Flags
1 1 256 137 0,0 drop active
1 2 10.37.11.151/24 6 23 2,0 drop active
1 3 17 68 67 0,0 drop active
1 4 256 161 0,0 drop active
1 5 256 53 0,0 drop active
1 6 10.37.11.151/29 256 accept active
1 7 10.37.11.196/29 10.11.0.98/32 256 accept active
1 8 10.37.11.195/32 10.11.0.98/32 6 drop active
1 9 10.37.11.195/32 10.11.0.98/32 256 accept active
1 10 10.37.11.194/32 10.11.0.98/16 6 accept active
1 11 10.37.11.193/32 10.11.0.98/8 17 drop active
1 12 10.37.11.192/32 10.11.0.98/32 6 F,F accept active
1 13 10.37.11.191/32 10.11.0.98/32 17 F,F accept active
1 14 10.37.11.190/32 10.11.0.98/24 17 8,F accept active
1 15 10.37.11.189/32 10.11.0.98/32 256 F,8 drop active
1 16 10.37.11.189/32 10.11.0.98/32 256 F,8 accept active
1 17 10.37.11.188/32 10.11.0.98/8 17 accept active
1 18 10.37.11.188/32 10.11.0.98/32 6 drop active
group
group-id
(Optional) Specifies the filter group to be displayed. The valid range is
1 to 256.
index
index-num
(Optional) Specifies the index of the particular filter within a group to
be displayed. The valid range is 1 to 128.
verbose
(Optional) Displays complete information about the filter groups in a
format that is easier to read than the default display.
Release
Modification
12.1(6)EC1
This command was introduced on the Cisco uBR7100 series and
Cisco uBR7200 series routers.
12.2(2)XF, 12.2(4)BC1 This command was supported on the Cisco uBR10012 routers.
12.2(8)BC2
An option was added to the
cable filter group
command to allow filter
groups to be activated and deactivated without removing the filter group’s
configuration.