5-99
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 5 Cisco CMTS Debugging Commands
debug hccp channel-switch
debug hccp channel-switch
To display debug messages related to an RF or channel switch that is being used for HCCP N+1 (1:n)
redundancy, use the
debug hccp channel-switch
command in privileged EXEC mode. To disable the
debug message output, use the
no
form of this command.
debug hccp channel-switch
no debug hccp channel-switch
Syntax Description
This command has no arguments or keywords.
Command Modes
Privileged EXEC
Command History
Usage Guidelines
The
debug hccp channel-switch
command displays debugging messages related to the SNMP messages
and other communication between the CMTS and an RF-switch or channel-switch during N+1 (1:n)
HCCP operations.
Note
You must use the
debug hccp events
command to activate HCCP event debugging before the
debug
hccp channel-switch
command will generate any debug output.
Examples
The following example shows typical output for the
debug hccp channel-switch
command:
Router#
debug hccp events
Router#
debug hccp channel-switch
HCCP channel action debugging is on
Mar 7 10:11:55:HCCP: snmp response error from 1.8.26.100.
Mar 7 10:12:16:HCCP: snmp response error from 1.8.26.100.
Mar 7 10:13:23:HCCP_SNMP: unknown Wavecom snmp type
Mar 7 10:12:21:HCCP: failed to make community
Mar 7 10:12:21:HCCP: failed to create snmp message
Mar 7 10:12:21:HCCP: SPrintVarBind() failed
Mar 7 10:12:21:HCCP: snmp request failed
Mar 7 10:12:21:HCCP: snmp request cancelled
Mar 7 11:51:50:HCCP: group 1 member 1 Working is loading config
Mar 7 11:51:52:HCCP: group 1 member 1 Working finished loading config
Release
Modification
12.2(4)XF1,
12.2(4)BC1
This command was introduced for the N+1 (1:n) RF Switch with the
Cisco uBR10012 router.
12.2(11)BC1
Support was added for the N+1 (1:n) RF Switch with the
Cisco uBR7246VXR router.