5-112
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 5 Cisco CMTS Debugging Commands
debug hccp timing
debug hccp timing
To display debug messages for the timing of HCCP events, use the
debug hccp timing
command in
privileged EXEC mode. To disable the debug message output, use the
no
form of this command.
debug hccp timing
[
if-config
]
no debug hccp timing
[
if-config
]
Syntax Description
Command Modes
Privileged EXEC
Command History
Usage Guidelines
You must activate the
debug hccp events
command before the
debug hccp timing
command will
generate any debug message output.
Examples
The following example shows typical output for the
debug hccp timing
command:
Router#
debug hccp events
Router#
debug hccp timing
HCCP timing measurement debugging is on
May 31 10:21:07.609 HCCP P is busy. Deactivating 1 6
May 31 10:21:07.609 HCCP P is busy. Deactivating 2 6
May 31 10:21:08.705 HCCP hwif_goingdown for Cable8/1/0. Deactivate 1 6
May 31 10:21:08.705 HCCP hwif_goingdown for Cable8/1/1. Deactivate 2 6
May 31 10:21:08.773 HCCP 2 6 Working: become standby - 68 msec
May 31 10:21:08.793 HCCP 1 6 Working: become standby - 20 msec
May 31 10:21:10.730 HCCP 1 1 Working: turn on "uc" - 8 msec
May 31 10:21:10.730 HCCP 1 1 Working: turn on "nru" - 0 msec
May 31 10:21:10.734 HCCP 1 1 Working: become active - 4 msec
May 31 10:21:10.774 HCCP 2 1 Working: turn on "uc" - 52 msec
May 31 10:21:10.774 HCCP 2 1 Working: turn on "nru" - 0 msec
May 31 10:21:10.774 HCCP 2 1 Working: become active - 0 msec
May 31 10:21:12.350 HCCP hwif_goingdown for Cable5/1/0. Deactivate 1 1
May 31 10:21:12.350 HCCP hwif_goingdown for Cable5/1/0. Deactivate 1 6
May 31 10:21:12.350 HCCP hwif_goingdown for Cable5/1/0. Deactivate 1 3
May 31 10:21:12.350 HCCP hwif_goingdown for Cable5/1/0. Deactivate 1 2
if-config
(Optional) Displays debugging messages showing the timing of the
reconfiguration of cable interfaces during HCCP redundancy operations.
Release
Modification
12.1(3a)EC
This command was introduced.
12.2(4)XF1,
12.2(4)BC1
Support was added for the N+1 (1:n) RF Switch with the Cisco uBR10012
router.
12.2(11)BC1
Support was added for the N+1 (1:n) RF Switch with the
Cisco uBR7246VXR router.
12.2(15)BC1 The
if-config
option was added.