6-54
Cisco Broadband Cable Command Reference Guide
OL-1581-07
Chapter 6 Cable CPE Commands
ip address docsis
Examples
The following example shows how to configure the cable access router so that it obtains the IP address
for its cable interface from a DHCP server:
Router(config)#
interface cable-modem 0
Router(config-if)#
ip address docsis
Router(config-if)#
exit
Router(config)#
Related Commands
Command
Description
cable-modem dhcp-proxy
Specifies that a DHCP server should provide the IP address for the
router’s Ethernet interface or for a NAT address pool.
ip http dhcp
Specifies the use of the DHCP protocol to obtain an IP address for
any interface except the cable interface at system power-on.
ip http negotiated
Specifies that a serial interface should use the PPP/IPCP to obtain
an IP address at system power-on