5-66
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 5 Cisco CMTS Debugging Commands
debug cable registration
The following example shows typical output when a CM attempts to come online without downloading
a DOCSIS configuration file from a TFTP server through the Cisco CMTS cable interface, when the
cable tftp-enforce
command has been used.
Router#
debug cable interface c3/0 verbose
Router#
debug cable registration
CMTS registration debugging is on
May 14 22:33:21.474: Registration request from 5555.7366.12fb, SID 2 on Cable3/0/U0
May 14 22:33:21.474: Cable Modem sent Registration Request without attempting TFTP
SLOT 3/0: May 14 22:33:21.474: %UBR7200-4-REGISTRATION_BEFORE_TFTP:
<133>CMTS[Cisco]:<????????> Registration request unexpected: Cable Modem did not attempt
TFTP. CM Mac Addr <5555.7366.12fb>
Registration failed for Cable Modem 5555.7366.12fb on interface Cable3/0/U0:
CoS/Sflow/Cfr/PHS failed in REG-REQ
May 14 22:33:21.474: REG-RSP Status : failure (2)
May 14 22:33:21.474: Registration Response:
May 14 22:33:21.474: 0x0000: C2 00 00 1B 00 00 00 50 73 4E B4 19 00 05 00 E0
May 14 22:33:21.474: 0x0010: 56 AC 00 09 00 00 03 01 07 00 00 02 02
May 14 22:33:21.474: Registration Response Transmitted
Tip
To monitor a specific CM when it comes online, use the
debug cable mac-address
,
debug cable
mac-protocol
, and
debug cable registration
commands.
Related Commands
Command
Description
debug cable interface
Enables debugging output for a specific cable interface.
debug cable
mac-protocol
Displays debugging output for the MAC layer protocol.
debug cable
mac-scheduler
Displays debugging output for the MAC layer scheduler and admission
control activities.
show controllers cable
Displays interface controller information for the specified slot.