3-12
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 3 Cisco CMTS Show Commands
show cable bundle
Table 3-4
describes the fields shown in the
show cable bundle
command display.
Tip
In Cisco IOS Release 12.1(12)EC, Release 12.2(8)BC1, and later releases, you can add a timestamp to
show
commands using the
exec prompt timestamp
command in line configuration mode.
Related Commands
Table 3-4
show cable bundle Command Field Descriptions
Field Description
MAC address
Identifies the MAC (hardware) address for each interface in the
bundle.
Interface
Identifies the cable interface slot and port number.
Flag
The current value of the flag byte for this bundle entry. The
following bits can be set:
•
Bit 0 (0x01) = Bundle is active.
•
Bit 1 (0x02) = Bundle is a static multicast group.
Note
If more than one bit is set, add the values together. For
example, 3 indicates an active, static multicast group.
Location
The location in the router’s memory for the flags byte for this
bundle entry. This value is useful only to TAC engineers during
debugging.
link
The value of the link pointer for this bundle entry. This value is
useful only to TAC engineers during debugging.
sublink
The value of the sublink pointer for this bundle entry. This value is
useful only to TAC engineers during debugging.
Command
Description
cable bundle
Creates an interface bundle.