3-119
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 3 Cisco CMTS Show Commands
show cable modem summary
show cable modem summary
To display a summary of CMs on one or more cable interfaces, use the
show cable modem
command in
privileged EXEC mode.
show cable modem summary
[
total
]
show cable modem summary
interface1
[
interface2
]
total
show cable modem summary
interface1
[
interface2
]
upstream
port1
port2
total
show cable modem
cable
slot/port
[
upstream
port
]
summary
show cable modem
cable
slot
/
subslot
/
port
[
upstream
port
]
summary
Syntax Description
Command Modes
Privileged EXEC
Command History
total
(Optional) Displays a footer line showing the totals for each column.
interface1
(Optional) Cable interface to be summarized. The
interface1
parameter can
take the following forms:
•
cable
slot
/
port
—On the Cisco uBR7100 series router, the only valid
value is
1/0
. On the Cisco uBR7200 series router,
slot
can range from 3
to 6, and
port
can be 0 or 1, depending on the cable interface.
•
cable
slot/subslot/port
—On the Cisco uBR10012 router,
slot
can range
from 5 to 8,
subslot
can be either 0 or 1, and
port
can range from 0 to 4
(depending on the interface).
interface2
(Optional) Second cable interface, specifying a range of cable interfaces to
be summarized. The
interface2
parameter has the same form as
interface1
.
Note
When specifying a range of cable interfaces,
interface1
must be the
lower-numbered interface and
interface2
must be the higher-
numbered interface.
upstream
port1 port2
(Optional) Specifies a range of upstream ports on the cable interfaces to be
summarized. The
port1
and
port2
parameters can start at 0, and
port2
must
be a higher-numbered port than
port1
.
upstream
port
(Optional) Specifies a specific upstream port to be summarized. This option
can be specified only when summarizing a single cable interface.
Release
Modification
11.3XA
This command was introduced.
12.1(4)CX and
12.2(4)BC1
Support was added for the Cisco uBR10012 router.
12.1(6)EC
The
total
option was supported for the Cisco uBR7100 series and
Cisco uBR7200 series routers.
12.1(11b)EC
The upstream Description field was added to the
show cable modem
summary
display in Cisco IOS Release 12.1 EC.