5-74
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 5 Cisco CMTS Debugging Commands
debug cable subscriber-monitoring
debug cable subscriber-monitoring
To display debugging messages the use of the
cable qos enforce-rule
command to enforce a particular
quality of service (QoS) profile, use the
debug cable subscriber-monitoring
command in privileged
EXEC mode. To stop the display of debugging messages, use the
no
form of this command.
debug cable subscriber-monitoring
no debug cable subscriber-monitoring
Syntax Description
This command has no arguments or keywords.
Defaults
No default behavior or values
Command Modes
Privileged EXEC
Command History
Usage Guidelines
Tip
Because this command can produce a large volume of debug information, use this command only when
you have also enabled debugging for a particular interface or MAC address, using the
debug cable
interface
and
debug cable mac-address
commands, respectively.
Examples
The following example shows how to enable debugging output using the
debug cable
subscriber-monitoring
command:
Router#
debug cable subscriber-monitoring
subscriber monitoring debugging is on
cmts_enf_map_sm_to_qos: enforced=9, penalty_life_time=10080
cmts_enf_map_sm_to_qos: Found rule #=9, rule_name=name, dir=US
cmts_enf_map_sm_to_registered_qos1: us smp=0x00, ds smp=0x1F
Related Commands
Release
Modification
12.2(15)BC1
This command was introduced.
Command
Description
cable qos enforce-rule
Creates an enforce-rule to be used to enforce a particular quality of service
(QoS) profile and enters enforce-rule configuration mode.
debug cable interface
Enables debugging output for a specific cable interface.