3-20
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 3 Cisco CMTS Show Commands
show cable dsg
show cable dsg
To display the current DOCSIS Set-Top Gateway (DSG) tunneling parameters, use the
show cable dsg
command in privileged EXEC mode.
show cable dsg
{
stats
|
tunnel
} [
vendor
CA-vendor-name
|
tunnel-mac-address
]
Syntax Description
Defaults
Displays information for all DSG tunnels.
Command Modes
Privileged EXEC
Command History
Examples
The following example shows a typical display for the
show cable dsg tunnel
command:
Router#
show cable dsg tunnel
Group-ip Src-ip Tunnel-MAC Interface Packets CA-vendor
225.2.2.2 * 0001.0002.0003 Cable3/0 1589 BBB
230.6.6.6 * 000d.000d.000d Cable3/0 12868464 abc
230.7.7.7 * 000e.000e.000e Cable3/0 24330138 abc
230.4.4.4 * 000b.000b.000b Cable3/0 22008648 cisco
230.5.5.5 * 000c.000c.000c Cable3/0 6424012 abc
229.1.1.1 * 0009.0009.0009 Cable3/0 12868440 cisco
228.1.1.1 * 0008.0008.0008 Cable3/0 6424012 cisco
230.1.1.1 * 000a.000a.000a Cable3/0 24370812 cisco
230.8.8.8 * 000f.000f.000f Cable3/0 23035116 abc
Router#
The following example shows a typical display for the
show cable dsg stats
command:
Router#
show cable dsg stats
stats
Displays configuration and run-time statistics about the currently-
defined DSG tunnels.
tunnel
Displays the mapping of DSG tunnels to vendors or well-known MAC
addresses.
vendor
CA-vendor-name
(Optional) Displays information about a specific Conditional Access
(CA) vendor. This parameter can be any arbitrary string up to 8
characters in length.
tunnel-MAC-address
(Optional) Displays information for the specified well-known MAC
address for the DSG tunnel. If you specify a MAC address of
0000.0000.0000, the command displays information for all DSG
tunnels, which is the default display.
Release
Modification
12.2(15)BC2
This command was introduced for the Cisco uBR7100 series and
Cisco uBR7246VXR routers.