4-98
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 4 Commands for the Cisco uBR10012 Router
switchover timeout
switchover timeout
To configure the switchover timeout period of the PRE1 module, use the
switchover timeout
command
in redundancy configuration (main-cpu) mode. To reset the timeout period to its default value, use the
no
form of this command.
switchover timeout
timeout-period
no switchover timeout
Syntax Description
Defaults
0
Command Modes
Redundancy configuration, main-cpu mode
Command History
Usage Guidelines
The
switchover timeout
command specifies how long the standby PRE module should wait when it does
not detect a heartbeat from the active PRE module before initiating a switchover and assuming
responsibility as the active PRE module. If set to 0, the standby PRE module initiates a switchover
immediately when the active PRE module misses a scheduled heartbeat.
Examples
The following example shows how to set the timeout period to 60 milliseconds:
Router#
config t
Router(config)#
redundancy
Router(config-r)#
main-cpu
Router(config-r-mc)#
switchover timeout 60
Router(config-r-mc)#
exit
Router(config-f)#
exit
Router(config)#
Related Commands
timeout-period
Specifies the timeout, in milliseconds. The valid range is 0 to 25000
milliseconds (25 seconds), where 0 specifies no timeout period.
Release
Modification
12.2(11)BC3
This command was introduced for the Cisco uBR10012 router.
Command
Description
main-cpu
Enters main-CPU redundancy configuration mode, so that you can
configure the synchronization of the active and standby Performance
Routing Engine (PRE1) modules.