3-65
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 3 Cisco CMTS Show Commands
show cable modem access-group
show cable modem access-group
To display the access groups for the CMs on a particular cable interface, use the
show cable modem
access-group
command in privileged EXEC mode.
Cisco uBR7100 series and Cisco uBR7200 series routers:
show cable modem
[
ip-address
|
cable
slot/port
[
upstream
port
] |
mac-address
]
access-group
Cisco uBR10012 routers:
show cable modem
cable
slot
/
subslot
/
port
[
upstream
port
]
access-group
Syntax Description
Command Modes
Privileged EXEC
Command History
ip-address
(Optional) Displays access-group information for the CM with the
specified IP address. (Cisco uBR7100 series and Cisco uBR7200
series routers only.)
mac-address
(Optional) Displays access-group information for the CM with the
specified MAC address. (Cisco uBR7100 series and Cisco uBR7200
series routers only.)
cable
slot/port
(Optional) Identifies the cable interface and downstream port on the
Cisco uBR7100 series and Cisco uBR7200 series routers.
On the Cisco uBR7100 series router, the only valid value is
1/0
. On
the Cisco uBR7200 series router,
slot
can range from 3 to 6, and
port
can be 0 or 1, depending on the cable interface.
cable
slot/subslot/port
Identifies the cable interface on the Cisco uBR10012 router. The
following are the valid values:
•
slot
= 5 to 8
•
subslot
= 0 or 1
•
port
= 0 to 4 (depending on the cable interface)
upstream
port
(Optional) Displays information for all CMs using this specific
upstream. You can specify this option only when displaying
information for a cable interface. The valid range for
port
begins with
0 and ends with a value that depends on the number of upstream ports
on the cable interface line card.
Release
Modification
11.3XA
This command was introduced.
12.2(4)BC1
Support for this command was added for the Cisco uBR10012 router, but
only to display access groups on a per-interface basis.