6-169
Cisco Broadband Cable Command Reference Guide
OL-1581-07
Chapter 6 Cable CPE Commands
show interfaces cable-modem
The following example shows typical output of the
show interfaces cable-modem accounting
command, which shows the number of packets and bytes of each protocol type that is passing through
the cable interface:
Router#
show interfaces cable-modem 0 accounting
cable-modem0
Protocol Pkts In Chars In Pkts Out Chars Out
IP 545 185502 159 90240
Trans. Bridge 3878 964995 12597 1611142
ARP 73 3066 86 4128
Router#
Table 6-31
describes the significant fields shown in this display.
The following example shows typical output for the
show interfaces cable-modem counters
command:
Router#
show interfaces cable-modem 0 counters
Cable specific counters:
Ranging requests sent : 50982
Downstream FIFO full : 0
Re-requests : 7277
collisions
Number of messages retransmitted due to an Ethernet collision.
Collisions are usually the result of an overextended LAN
(Ethernet or transceiver cable too long, more than two repeaters
between stations, or too many cascaded multiport transceivers).
A packet that collides is counted only once in output packets.
interface resets
Number of times an interface has been completely reset. A reset
can happen if packets queued for transmission were not sent
within several seconds. On a serial line, this can be caused by a
malfunctioning modem that is not supplying the transmit clock
signal, or by a cable problem. If the system notices that the
carrier detect line of a serial interface is up, but the line protocol
is down, it periodically resets the interface in an effort to restart
it. Interface resets can also occur when an interface is looped
back or shut down.
output buffer failures
Number of times the output buffer has failed.
output buffers swapped out
Number of times the output buffer has been swapped out.
Table 6-30 show interfaces cable-modem Field Descriptions (continued)
Field
Description
Table 6-31 show interfaces cable-modem accounting Field Descriptions
Field
Description
Protocol
List of protocols operating on the cable-modem interface.
Pkts In
Number of packets of each protocol received on the interface.
Chars In
Number of bytes of each protocol received on the interface.
Pkts Out
Number of packets of each protocol sent on the interface.
Chars Out
Number of bytes of cache protocol sent on the interface.