2-266
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 2 Cisco CMTS Configuration Commands
cable telco-return spd password
cable telco-return spd password
To set the password that the telco-return CM uses for authentication when establishing a PPP connection
with the access server, use the
cable telco-return spd password
command in cable interface
configuration mode. To restore the default value, use the
no
form of this command.
cable telco-return spd
spd-number
password
password-string
no cable telco-return spd
spd-number
password
Syntax Description
Defaults
No password is used.
Command Modes
Interface configuration (cable interface only)
Command History
Usage Guidelines
This command sets the Login Password parameter for the specified SPD in Telephony Channel
Descriptor (TCD) messages.
Note
This command is available only in images that support telco-return. These images have a “t” as part of
the image name.
Examples
The following example shows how to set the password to 9JwoKd7
in service provider descriptor 2:
router(config-if)#
cable telco-return spd 2 password 9JwoKd7
Related Commands
spd-number
Service provider descriptor (SPD) number for which this parameter is
set. Valid range is 1 through 5.
password-string
Login password that the CM uses for authentication during the
initialization procedure.
Release
Modification
12.0(4)XI
This command was introduced.
Command Description
cable telco-return enable
Enables telco-return functionality.
cable telco-return interval
Defines the interval for sending TCD and Termination System
Information (TSI) messages.
cable telco-return
registration-ip
Selects a different IP address for the telco-return CM to send its
registration requests.
