6-157
Cisco Broadband Cable Command Reference Guide
OL-1581-07
Chapter 6 Cable CPE Commands
show crypto engine connections
Interface IP-Address Drop Count
Ethernet0/0 192.168.100.165 4
Router#
Table 6-25
describes the fields shown in the display.
The following example shows typical output for the
show crypto engine connections flow
command:
Router#
show crypto engine connections flow
flow_id ah_conn_id esp_conn_id comp_spi
3 0 0 0
4 0 0 0
7 0 0 0
8 0 0 0
9 0 0 0
10 0 0 0
11 0 0 0
12 0 0 0
13 0 0 0
14 0 0 0
36 0 0 0
37 0 0 0
38 0 0 0
39 0 0 0
Router#
Table 6-26
describes the fields shown in the display.
Tip
In Cisco IOS Release 12.2(8)T and later releases, you can add a timestamp to
show
commands using the
exec prompt timestamp
command in line configuration mode.
Table 6-25 show crypto engine connections dropped-packet Field Description
Field
Description
Interface
Interface involved in the encrypted session connection.
IP-Address
IP address of the interface.
Drop Count
Total number of dropped packets since the last reset of the
router.
Table 6-26 show crypto engine connections flow Field Description
Field
Description
flow_id
Unique identifier for this flow.
ah_conn_id
Unique identifier for the flow’s Authentication Header.
esp_conn_id
Unique Identifier for the flow’s Encapsulating Security
Protocol (ESP).
comp_spi
Security Parameter Index (SPI)—An arbitrary number that
unique identifies the flow’s security association.