5-12
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 5 Cisco CMTS Debugging Commands
debug cable bundle
debug cable bundle
To enable debugging of the bundling of cable interfaces, use the
debug cable bundle
command in
privileged EXEC mode. To disable debugging output, use the
no
form of the command.
debug cable bundle
[
pkt
]
no debug cable bundle
[
pkt
]
Syntax Description
Command Modes
Privileged EXEC
Command History
Usage Guidelines
This command activates debugging for cable interfaces that are bundled together into a master/slave
relationship, using the
cable bundle
command.
Note
The
debug cable bundle pkt
command does not display information about multicast packets on the
Cisco uBR10012 router. Use the
show ip mroute count
and
show hardware pxf cpu mroute
commands
to display this information on the Cisco uBR10012 router.
Tip
This command can generate a significant amount of output. To limit the debug output to a specific cable
interface, use the
debug cable interface
command, before using the
debug cable bundle
command.
Examples
The following shows typical output from the
debug cable bundle
command for a particular cable
interface:
Router#
debug cable interface c3/0
Router#
debug cable bundle
00:53:23: Sending multicast packet to bundle int Cable3/0
00:53:23: Unicast packet sent out bundle int Cable3/0 to 0003.e3fa.5e21
00:53:24: Sending multicast packet to bundle int Cable3/0
00:53:25: Sending multicast packet to bundle int Cable3/0
00:53:26: Sending multicast packet to bundle int Cable3/0
Router#
pkt
(Optional) Displays detailed information about packets that are transmitted
over the cable bundle.
Release
Modification
12.0(7)XR, 12.1(0)6SC,
12.1(2)EC1
This command was introduced.
12.1(3a)EC
Subinterface support was added.