2-258
Cisco Broadband Cable Command Reference Guide
OL-1581-08
Chapter 2 Cisco CMTS Configuration Commands
cable telco-return spd dhcp-server
cable telco-return spd dhcp-server
To identify the IP address of the Dynamic Host Configuration Protocol (DHCP) server that the telco-
return CM must access, use the
cable telco-return spd dhcp-server
command in cable interface
configuration mode. To restore the default value, use the
no
form of this command.
cable telco-return spd
spd-number
dhcp-server
ip-address
no cable telco-return spd
spd-number
dhcp-server
Syntax Description
Defaults
The IP address is set to 0.
Command Modes
Interface configuration (cable interface only)
Command History
Usage Guidelines
This command sets the DHCP Server parameter in the specified SPD in Telephony Channel Descriptor
(TCD) messages. Telco-return CMs use the DHCP server that is identified by this IP address if the
cable
telco-return spd dhcp-authenticate
command is configured. If the
cable telco-return spd dhcp-
authenticate
command is not configured, the CMs use any available DHCP server.
Note
This command is available only in images that support telco-return. These images have a “t” as part of
the image name.
Examples
The following example indicates that for SPD 2, CMs must use the DHCP server identified by IP address
192.168.255.255:
router(config-if)# c
able telco-return spd 2 dhcp-authenticate
router(config-if)#
cable telco-return spd 2 dhcp-server 192.168.255.255
Related Commands
spd-number
Service provider descriptor (SPD) number for which this parameter is
set. Valid range is 1 through 5.
ip
-
address
IP address of the DHCP server that CMs must use.
Release
Modification
12.0(4)XI
This command was introduced.
Command Description
cable telco-return enable
Enables telco-return functionality.
cable telco-return interval
Defines the interval for sending TCD and Termination System
Information (TSI) messages.
