Command Manual ( For Soliton ) – Port Security-Port Binding
H3C S3100 Series Ethernet Switches
Chapter 1 Port Security Commands
1-18
Note:
z
Before setting the security mode to
autolearn
, you need to use the
port-security
max-mac-count
command to configure the maximum number of MAC addresses
allowed on the port.
z
When a port operates in the
autolearn
mode, you cannot change the maximum
number of MAC addresses allowed on the port.
z
After setting the security mode to
autolearn
, you cannot configure static or
blackhole MAC addresses on the port.
z
When the port security mode is not
noRestriction
, you need to use the
undo
port-security port-mode
command to change it back to
noRestriction
before you
change the port security mode to other modes.
On a port configured with a security mode, you cannot do the following:
z
Configure the maximum number of MAC addresses that can be learned.
z
Configure the port as a reflector port for port mirroring.
z
Configure link aggregation.
Related commands:
display port-security
.
Examples
# Set the security mode of Ethernet 1/0/1 on the switch to
userLogin
.
<Sysname> system-view
System View: return to User View with Ctrl+Z.
[Sysname] port-security enable
[Sysname] interface Ethernet 1/0/1
[Sysname-Ethernet1/0/1] port-security port-mode userlogin
1.1.11 port-security timer disableport
Syntax
port-security timer disableport timer
undo port-security timer disableport
View
System view
Parameters
timer
: This argument ranges from 20 to 300, in seconds.
