Command Manual (For Soliton) – IPv6 Management
H3C S3100 Series Ethernet Switches
Chapter 1 IPv6 Configuration Commands
1-7
Field
Description
Physical
Interface link state:
z
*down: Indicates the VLAN interface is administratively
down; that is, the interface is shut down using the
shutdown
command.
z
down: Indicates the VLAN interface is administratively
up but its physical state is down; that is, no port in the
VLAN is up, which may be caused by a link failure.
z
up: Indicates the administrative and physical states of
the VLAN interface are both up.
Protocol
Link protocol state of an interface
z
down: Indicates the link layer protocol state of the
VLAN interface is down, generally because no IP
address is configured.
z
up: Indicates the link layer protocol state of the VLAN
interface is up.
IPv6 Address
IPv6 address of the interface (If no address is configured
for the interface, “Unassigned” will be displayed.)
1.1.5 display ipv6 neighbors
Syntax
display ipv6 neighbors
{
ipv6-address | all | dynamic
|
static
|
interface
interface-type interface-number
|
vlan
vlan-id
} [
|
{
begin
|
exclude
|
include
}
regular-expression
]
View
Any view
Parameters
ipv6-address
: IPv6 address whose neighbor information is to be displayed.
all
: Displays information of all neighbors, including neighbors acquired dynamically and
configured statically.
dynamic
: Displays information of all neighbors acquired dynamically.
static
: Displays information of all neighbors configured statically.
interface interface-type interface-number
: Displays information of the neighbors of a
specified interface.
vlan
vlan-id
: Displays information of the neighbors of a specified VLAN, in the range of
1 to 4094.
|
: Uses a regular expression to match neighbor entries.
regular-expression
: A case-sensitive string for matching.
