Command Manual (For Soliton) – SNMP-RMON
H3C S3100 Series Ethernet Switches
Chapter 1 SNMP Configuration Commands
1-12
Field
Description
Storage-type
Storage type, which can be:
z
volatile: Information will be lost if the system is rebooted
z
nonVolatile: Information will not be lost if the system is
rebooted
z
permanent: Modification is permitted, but deletion is
forbidden
z
readOnly: Read only, that is, no modification, no deletion
z
other: Other storage types
UserStatus
SNMP user status
1.1.9 enable snmp trap updown
Syntax
enable snmp trap updown
undo enable snmp trap updown
View
Ethernet port view, interface view
Parameters
None
Description
Use the
enable snmp trap updown
command to enable the sending of port/interface
linkUp/linkDown traps.
Use the
undo enable snmp trap updown
command to disable the sending of
linkUp/linkDown traps.
By default, the sending of port/interface linkUp/linkDown traps is enabled.
Note that you need to enable the generation of port/interface linkUp/linkDown traps
both on the port/interface and globally if you want a port/interface to generate
port/interface linkUp/linkDown traps when the state of the port/interface changes.
To enable this function on a port/interface, use the
enable snmp trap updown
command; to enable this function globally, use the
snmp-agent trap enable
[
standard
[
linkdown
|
linkup
] * ] command. By default, both are enabled.
Examples
# Enable the port Ethernet 1/0/1 to send linkUp/linkDown SNMP traps to the NMS
whose IP address is 10.1.1.1 using the community name
public
.
<Sysname> system-view