Command Manual (For Soliton) – VLAN
H3C S3100 Series Ethernet Switches
Chapter 1 VLAN Configuration Commands
1-3
Table 1-1
Description on the fields of the
display interface Vlan-interface
command
Field
Description
Vlan-interface1 current
state
The state of the VLAN interface, which can be one of
the following:
z
Administratively DOWN: This VLAN interface has
been manually disabled with the
shutdown
command.
z
DOWN: The administrative state of this VLAN
interface is up, but its physical state is down. It
indicates that the VLAN corresponding to this
interface does not contain ports in up state
(possibly because the lines have failed).
z
UP: The administrative and physical states of this
VLAN interface are both up.
Line protocol current state
The link layer protocol state of the VLAN interface,
which can be one of the following:
z
DOWN: The protocol state of this VLAN interface
is down, usually because no IP address is
configured.
z
UP: The protocol state of this VLAN interface is
up.
IP Sending Frames' Format
is PKTFMT_ETHNT_2
Format of the frames sent from the VLAN interface.
PKTFMT_ETHNT 2 indicates that this VLAN
interface sends Ethernet II frames. Refer to the VLAN
configuration part in the accompanied operation
manual for information about frame formats.
Hardware address
MAC address corresponding to the VLAN interface
Internet Address
IP address corresponding to the VLAN interface
10.1.1.1/24 Primary
Primary IP address of this VLAN interface
Description Description
string of the VLAN interface
The Maximum Transmit Unit
Maximum transmission unit (MTU)
Note:
For information about how to configure an IP address for a VLAN interface, refer to the
description on the
ip address
command in the
IP Address and Performance Command
part.
1.1.3 display vlan
Syntax
display
vlan
[
vlan-id1
[
to
vlan-id
2 ] |
all
|
dynamic
|
static
]